Skip to content
Back to Learn

USB To UART+JTAG: install your DMA card driver

USB To UART+JTAG under Other devices is your DMA card's JTAG port without its driver. Install the CH347 driver in MewTools and its dot turns green.
GuideUpdated · phantom · 504 reads

USB To UART+JTAG under Other devices in Device Manager is the GODLIKE 100T's JTAG port without its driver, and the name comes from the CH347 chip behind that port. You need the driver to get your DNA ID and to flash.

How to fix it

Common questions

  • Which driver does a DMA card's JTAG port use?
    On the GODLIKE 100T, the WCH CH347 driver. Press Install next to Card firmware cable in MewTools.
  • What do I need the JTAG port for?
    Getting your DNA ID and flashing. Your software uses the data port.

Still not green

  • The cable is in the data port.
    For flashing it goes in the JTAG port, the one nearest the gold strip.
  • Your card has no power.
    Your main PC has to be on, and if your card isn't flashed yet, keep it in the BIOS. DO NOT boot into Windows with your card plugged in until it's flashed. If you already did, reinstall Windows on your main PC before launching any games.
  • The kill switch is off.
    Shut your main PC down, turn the kill switch on, then start your PC again.
  • All of that is right.
    Cold boot both PCs, with your main PC going back into the BIOS, then press Check again.

For anything else, see MewTools will not flash. Every step is in Flashing your firmware, and other errors are in DMA error messages.

Are we missing something?

Tell us what you came looking for and couldn't find, or what we got wrong, and we'll look into it. No account needed.

Did this help?

You don't need an account, this tells us what to write more of.