Skip to content
Back to Learn

TINY PCIe TLP Algorithm auto-selected: DMA fix

Your DMA software fell back to tiny, slow reads because your card can't read memory. The most common cause is a card that hasn't been activated, so check the activator first.
GuideUpdated · phantom · 560 reads

"FPGA: TINY PCIe TLP Algorithm auto-selected!" means your DMA software tried to read your main PC's memory the normal way and the read didn't come back. It dropped to tiny reads instead. With our firmware the most common reason is that you haven't run the activator. Your card can't read memory until you activate it with your key.

What it means

Most DMA software is built on LeechCore, and this is its message. While it starts up, LeechCore tests a normal 4 KB read, and if that read fails it switches to tiny reads of 128 bytes, which are much slower. LeechCore spells it "FPGA: TINY PCIe TLP algrithm auto-selected!" with the typo, and it's the same error.

You still get this without the activator even when the flash worked, the lights are on and your card shows in Device Manager. It's often the line right before [FAIL] VMM INIT FAILED. or Unable to locate valid DTB, so look above those in the log too.

How to fix it

  • Run the activator.
    It's on your order page with your key. Open it on your second PC, paste the key, tick remember key and press activate device. A tick means it's active. More on the key in Your activation key.
  • Activate again after every restart of your main PC.
    That includes a cold boot.
  • Close your software and open it again once the activator shows the tick.

On MiTM it's a different app, so use the MiTM activator and your MiTM key.

Common questions

  • Does TINY PCIe TLP mean my flash failed?
    No. You get it when Mew Activator hasn't run, even when the flash worked, your card's lights are on and it shows in Device Manager.
  • Do I run Mew Activator again after a cold boot?
    Yes. You run it after every restart of your main PC.
  • Why does my log say "algrithm"?
    LeechCore spells it that way, and it's the same error.

Still there after activating

Then the reads are failing on the link between your card and your second PC.

If that doesn't fix it, go through Low DMA speed. If it still shows, open a ticket in our Discord with a screenshot of the whole log. Every other error is in DMA error messages.

Are we missing something?

Tell us what you came looking for and couldn't find, or what we got wrong, and we'll look into it. No account needed.

Did this help?

You don't need an account, this tells us what to write more of.